3D Treat Holder

I created this 3D Treat Holder using the new 2022-2024 InColors and the Cup of Tea Bundle.

I created this fun 3D Treat Holder using the new 2022-2024 InColors. The colors are bright and full of energy making them so much fun to work with. I also used the new stamp set, “Cup of Tea” and the coordinating “Teacup” dies. Each treat holder will hold 1 individual Ferrero Rocher candy.

I made 10 of these for a recent card workshop as a table gift for each attendee and of course, I made each different using all of the new In Colors. They loved them!


  • Starry Sky 2″ x 10″
  • Starry Sky 3″ x 3″
  • Basic White 4″ x 5 1/4″ – for stamping
  • Metallic Woven Ribbon – 6″
  • Simply Elegant Trim – 11″


  1. Start with the 2″ x 10″ Starry Sky cardstock, score at 4″ from both ends
  2. Fold and using your Bone Folder, crease all the score lines
  3. Using the Delightful Tag Topper (Retired), punch each end
  4. Score the 3″ x 3″ Starry Sky cardstock at 1/2″ on all 4 sides
  5. On this same piece of cardstock and using your Paper Snips, cut on 2 sides on the score lines up to the 1/2″ score line
  6. Fold and using your Bone Folder, crease all the score lines
  7. Using the Layering Circles Dies, cut a circle in the center of this panel using the 2nd smallest circle (measures approx 1 3/8″ diameter)
  8. Apply Multipurpose Liquid Glue to the cut tabs fold them inward
  9. Press and hold for a few seconds to let glue dry
  10. Repeat on the other side
  11. Apply Multipurpose Liquid Glue to two of the sides of this box and adhere it into the 2″ x 10″ panel between the score lines
  12. Stamp the cup in your choice of the 5 In Colors, the greenery image in Parakeet Party, the flowers in a combination of the 5 In Colors
  13. Die cut the cup, the flowers, and the greenery
  14. Die cut the large tag in Sweet Sorbet and in Basic White
  15. Stamp the word “enjoy” on the Basic White die cut tag in your choice of the 5 In Colors
  16. Using Multipurpose Liquid Glue, adhere the two tags together
  17. Using your Take Your Pick tool, poke a hole in the top of the tags
  18. Adhere the flowers to the greenery, the greenery to the top of the cup and then the entire image to one side of your base using Multipurpose Liquid Glue
  19. TIP: I only used the Multipurpose Liquid Glue on the tea cup, not the entire image
  20. Insert your candy
  21. Pull the 2 sides together at the top and tie a knot with the Metallic Woven Ribbon
  22. Insert the gold trim through the hole at the top of the tags
  23. Tie into a bow around the Metallic Woven Ribbon
This side view of the 3D Treat Holder shows the table that holds the Ferrero Rocher candy.

This really is an easy treat to make and can be done in any color choice. I hope you’ll give this a try and let me know how it went for you!

Product List

I hope I have inspired you to try one of these fun treat holders. Make a great treat for a tea party, bridal shower, or even a baby shower. Just switch up the colors and the design on the front.

1 thought on “3D Treat Holder”

Leave a Comment